Royal Enfield Interceptor 650 - Owner's Manual > Hand levers, centre and side stand pivots

Minor Maintenance Tips / Hand levers, centre and side stand pivots

The following simple maintenance activities will help maintaining your motorcycle. However, for an complete maintenance, we recommend you to get in touch with a Royal Enfield Authorised Service Centre.

  • Clean the pivot points and ensure they are free of any dirt, grime, rust, etc.
  • Lubricate the pivots.

Minor Maintenance Tips

NOTE

Wipe off the excess lubricant to prevent dirt and grime from accumulating.

DRIVE CHAIN

Minor Maintenance Tips

  • Spray drive chain with recommended chain cleaning solvent while simultaneously rotating rear wheel.
  • Ensure the drive chain has been sufficiently and completely covered with the cleaning solvent. If necessary use a suitable brush to remove hard deposits from the chain.
  • Wait for a few minutes and clean the chain thoroughly from any dirt, grime, etc.
  • Rotate rear wheel slowly and simultaneously apply recommended chain lubricant on the chain links.
  • Wipe off excess chain lubricant after a few minutes with a clean cloth.

Minor Maintenance Tips

ENGINE OIL LEVEL CHECKING

  • Ensure vehicle is in center stand on ground level
  • Start the vehicle and gently raise it to approx. 3000 RPM only for 10 seconds.
  • Leave the vehicle in idling speed condition for 15 seconds.
  • Switch off the engine and wait for 10 minutes for oil to settle down.
  • Engine oil level should be close to "MAX" condition.
  • If in case of oil level is not in above mentioned condition, then top-up the oil to "MAX" condition and repeat the procedure.
  • Do not overfill above the "MAX" mark as it may affect the clutch function.

Minor Maintenance Tips

ENGINE OIL DRAINING

  • Ensure vehicle is in center stand on ground level.
  • Engine oil should always be drained when the engine is warmed up sufficiently so that the oil drains faster.
  • Switch OFF ignition key and wait for 10 minutes for oil to settle down.
  • Remove the oil drain bolt and wait for 5 minutes minimum till the engine oil drains completely.
  • Drained engine oil quantity will be approx 2.2 liters to 2.9 liters (Oil drain quantity will vary depend on Kilometre covered).

Minor Maintenance Tips

OIL FILLING DURING OIL SERVICE

  • Ensure vehicle is in center stand on ground level.
  • Clean the oil filter joint face in crankcase and new oil filter to be assembled along with new rubber gasket.
  • Clean the oil drain hole joint face in oil pan and drain bolt.
  • New washer to be used. Assemble the drain bolt with the specified loctite.
  • Remove the oil filler plug & clean the oil filler cap joint face in crankcase and filler plug.
  • Refill the specified fresh engine oil quantity 3.1 litres.
  • New oil filler plug 'O' ring to be used and assemble the oil filler plug into the crankcase.
  • Check the oil level as per oil level checking procedure given below.

Minor Maintenance Tips

    See also:

     Royal Enfield Interceptor 650 - Owner's Manual > Minor Maintenance Tips

     Royal Enfield Interceptor 650 - Owner's Manual > Spark plug

    CLEANING SPARK PLUG AND ADJUSTING GAP Disconnect spark plug caps from the spark plugs. Locate spark plug spanner on the spark plug, loosen spark plug and remove it from cylinder head. Check spark plug for carbon deposits and centre electrodes for uneven wear. Clean spark plug by positioning it in a spark plug cleaning machine. Remove spark plug from the cleaning machine, check and set electrode gap between 0.7 to 0.8 mm. Position spark plug in the spark plug testing machine and check for proper functioning of the spark plug. Always replace spark plugs ONLY as per recommended specification. Apply a thin film of "anti seize" on the spark plug mounting and threads fix the spark plug by hand tightening. Tighten spark plug to torque 10 to 15 Nm by using a spark plug spanner.

    Motorcycles: