Royal Enfield Interceptor 650 - Owner's Manual > Engine kill switch
Engine "OFF"
Engine "ON"
CAUTION
- Turn off ignition switch when engine is not running. Failure to do so will discharge the battery due to the headlamp being continuously "ON".
E-START SWITCH
Depress and hold untill engine starts for a maximum of 5 seconds.
HORN
Press the horn button to sound horn.
HI BEAM / LOW BEAM SWITCH
- When the headlamp is in ON condition "High / Low beam" will be selected by toggling the switch. High beam indicator lamp located in instrument cluster will glow when high beam is selected.
High beam
Low beam
DAY FLASH
Press the switch for Day flash.
TURN SIGNAL SWITCH
Left turn signal "ON"
Right turn signal "ON"
"OFF" (Push to cancel)
Push the button from "OFF" position to either left or right before turning as needed and restore to "OFF" position to stop blinking.
Side panel
SIDE PANEL LEFT
- To access the left side panel remove the seat and retaining screw, pull and disengage the side panel from locater and gently remove the side panel.
SIDE PANEL RIGHT
- Turn key clockwise to unlock the side panel.
- Pull the side panel along with key to gently remove the side panel.
See also:
Royal Enfield Interceptor 650 - Owner's Manual > Ignition switch
OFF: Steering unlock, ignition "OFF" ON: Steering unlock, ignition "ON"
Royal Enfield Interceptor 650 - Owner's Manual > Instrument cluster
This instrument cluster consists of the following: Speedometer Odometer Selection Button Trip Meter 'A' and 'B' Turn Signal Indicator Hi beam Indicator Engine Malfunction Indicator Battery Low Voltage Indicator Fuel Level Indicator ABS Indicator Neutral Indicator Low Oil Pressure Indicator Tachometer